|(external link)||(external link)(external link)|
|All landowners/occupiers in the Waikato are responsible for the control of wooly nightshade on their property.|
All landowners/occupiers are responsible for controlling woolly nightshade on their properties and are required to work with Waikato Regional Council in areas where control programmes are in place. Woolly nightshade is also banned from being sold, propagated, distributed or included in commercial displays.
Small plants (less than 60cm) can be pulled out and left to dry after shaking all dirt from the roots. Larger plants that are cut down need to have the stump treated with herbicide or they will regrow. Try not to disturb the soil.
Cut the tree down, leaving a stump no higher than 5cm above ground level. Immediately (within two minutes of cutting) paint herbicide over the entire stump surface, including the sides.
Drill 10mm holes around the trunk at a 45 degree angle, 50mm deep and 50mm apart. Fill each hole with herbicide.
To control larger trees, make shallow downward cuts around the trunk below the lowest branch and near the ground using a machete or axe. Cuts should overlap to effectively ringbark the tree. Apply herbicide liberally to each cut.
Using a specific basal treatment herbicide* liberally paint or spray the trunk from the ground to a height of 30cm to 50cm, making sure to cover the entire trunk. *Talk to your local herbicide retailer for more information.
Totally cover the leaf surfaces with herbicide. This method is most suitable for smaller plants, but pulling out plants by hand may be cheaper and easier.
|Glyphosate||Drill and inject, stump swabbing, stem frilling (Note: Glyphosate is NOT suitable for overall spraying).|
|Amitrole||Drill and inject, stump swabbing, stem frilling, spray application.|
|Triclopyr||Stump swabbing, drill and inject, stem frilling, trunk base treatment.|
|Picloram gel||DStump swabbing.|
|Triclopyr/picloram mix||Drill and inject, stump swabbing, stem frilling, spray application.|
|Herbicide rules will apply. You may need to notify neighbours if spraying. The Waikato Regional Plan explains the agrichemical (herbicides) use rule in section 6.2.|
|If applying herbicide over water, a resource consent may be required. Please check with Waikato Regional Council before you begin.|
After initial control, it’s important to:
View, download or order the following publications or call our freephone 0800 800 401.